Advertisement · 728 × 90

Posts by CNX Software

Preview
$15 STM32U575 development board features FPC display connector, microSD card slot, two 48-pin GPIO headers - CNX Software A few days ago, we looked at the WeAct Studio STM32U585CIU6 development board, which features an ultra-low-power STM32U5 Cortex-M33 MCU and was added to
1 hour ago 0 0 0 0
Preview
Bee Write Back - A Raspberry Pi Zero 2 W-based DIY writerdeck with 5.5-inch OLED and mechanical keyboard - CNX Software Based on Raspberry Pi Zero 2 W, the Bee Write Back writerdeck is another DIY project that should be relatively easy to reproduce, since it relies on
1 day ago 1 0 0 0
Preview
Feature-rich Raspberry Pi CM5 carrier board offers dual Ethernet, quad RS485, 4G LTE/5G connectivity, and more - CNX Software Waveshare CM5-ETH-RS485-4G-BASE Raspberry Pi CM5 carrier board offers plenty of features such as GbE and 2.5GbE RJ45 jacks, optional 4G LTE/5G
1 day ago 0 0 0 0
Preview
Raspberry Pi SBC gets (analog and) digital radio HAT with AM, FM, DAB, DAB+, HD radio - CNX Software Yesterday, I wrote about a 2-year-old open-source hardware ESP32-based DAB+ receiver project, but it turns out there's also a digital radio project for
1 day ago 1 1 0 0
Preview
Open-source hardware DAB+ receiver combines ESP32 SoC with Skyworks SI4684 chip - CNX Software When I wrote about a DIY ESP32-S3 internet radio last week, "raspbeguy" commented he'd rather choose an ESP32-based DIY DAB+ receiver kit, such as the one
1 day ago 0 0 0 0
Preview
Sipeed T256s - A USB thermal camera with 256×192 LWIR sensor, up to 640x480 super AI resolution - CNX Software Sipeed T256s is a portable USB thermal camera equipped with a native 256×192 Long-Wave Infrared (LWIR) sensor and a built-in 2.4 TOPS NPU for
2 days ago 0 0 0 0
Preview
Flash Bee - An ESP32-C3-based DIY handheld lightning detector - CNX Software Flash Bee is an easy-to-make DIY handheld lightning detector based on off-the-shelf parts such as the XIAO ESP32C3 board and the Round Display for XIAO,
2 days ago 0 0 0 0
Advertisement
Preview
WeAct STM32U585CIU6 Core Mini - An $8 STM32U5 board supported by MicroPython v1.28 - CNX Software While checking out MicroPython v1.28 changelog, I noticed a board from WeAct Studio based on ST's STM32U5 Cortex-M33 microcontroller: the WeAct
2 days ago 1 0 0 0
Preview
ASUS Zenbook A16 - A $1699 Qualcomm Snapdragon X2 Elite Extreme CoPilot+ laptop - CNX Software ASUS Zenbook A16 is one of the first Copilot+ PCs/laptops based on the Qualcomm Snapdragon X2 Elite Extreme 18-core Armv9 SoC and is now available for
3 days ago 0 0 0 0
Preview
GL.iNet Comet 5G - A KVM over IP solution with 5G RedCap Cellular connectivity, 3.69-inch touchscreen display - CNX Software GL.inet Comet 5G (GL-RM10RC) is a KVM over IP solution with a 3.69-inch touchscreen display and 5G RedCap (Reduced Capability) IoT cellular connectivity,
3 days ago 0 0 0 0
Preview
AMD EPYC Embedded 8004 eATX motherboard supports up to 576GB DDR5 memory for Edge AI applications - CNX Software IBASE Technology MBB1002 eATX (Extended ATX) motherboard is powered by AMD EPYC Embedded 8004 series processors and takes up to 576GB DDR5-4800 ECC memory
3 days ago 0 0 0 0
Preview
SN1 Solar Node - An ESP32-C3-based board with IP67 enclosure, solar charging, ESPHome firmware - CNX Software Designed by Granz Scientific LLC, the SN1 Solar Node is an ESP32-C3-based IoT node/development board designed specifically for off-grid IoT projects.
3 days ago 0 0 0 0
Preview
wolfIP - An open-source, lightweight TCP/IP stack with no dynamic memory allocations for embedded systems - CNX Software Better known for its open-source wolfSSL SSL/TLS library, wolfSSL (the company) has now released the wolfIP open-source, lightweight TCP/IP stack with no
4 days ago 0 0 0 0
Preview
NASA Artemis Watch 2.0 - An ESP32-S3-powered, NASA-inspired wearable kit for education - CNX Software CircuitMess NASA Artemis Watch 2.0 is a programmable, NASA-themed smartwatch based on an ESP32-S3 WiFi and Bluetooth module and a 1.14-inch monochrome
4 days ago 0 0 0 0
Preview
AAEON Intelli TWL01 Edge fanless mini PC features up to Core 3 N355 Twin Lake CPU for kiosks and digital signage applications - CNX Software AAEON Intelli TWL01 Edge is an industrial mini PC with dual 4K display support powered by an Alder Lake-N/Twin Lake processor up to the Intel Core 3 N355
5 days ago 0 0 0 0
Preview
$2 WeAct CH32V006F8U6 Mini Core board features CH32V006 RISC-V MCU, supports 3.3V or 5V I/O voltage - CNX Software WeAct CH32V006F8U6 Mini Core is an inexpensive, tiny development board based on the 48 MHz CH32V006 RISC-V microcontroller and equipped with a USB-C port,
5 days ago 1 0 0 0
Preview
Advantech MIO-5356 - An industrial 3.5-inch SBC based on Intel Core Series 3 "Wildcat Lake" SoC - CNX Software Advantech MIO-5356 is the very first hardware platform based on the upcoming Intel Core Series 3 (Core 300) "Wildcat Lake" SoC we've seen. It's a 3.5-inch
5 days ago 0 0 0 0
Advertisement
Preview
ESP32-S3 gets post-quantum encryption with Aethyr Edge Node open-source firmware - CNX Software Aethyr Research has released post-quantum encrypted IoT edge node firmware for ESP32-S3 targets that boots in 2.1 seconds and supports full PQC (Post
6 days ago 0 0 0 0
Preview
Velxio is an open-source, self-hosted Arduino, Raspberry Pi, and ESP32 simulator - CNX Software Velxio is an open-source, self-hosted simulator for Arduino, ESP32, and Raspberry Pi boards that works directly in your web browser. You can drag-and-drop
1 week ago 2 1 0 0
Preview
Realtek RTL8159 10GbE to USB 3.2 adapters sell for about $55 and up - CNX Software Realtek unveiled low-cost, low-power 10GbE RTL8127 (PCIe) and RTL8159 (USB 3.0) controllers at Computex 2025. Since then, we noted that RTL8127-based M.2
1 week ago 1 0 0 0
Preview
SupTronics X1208 - A UPS + M.2 NVMe SSD HAT for the Raspberry Pi 5 - CNX Software The SupTronics X1208 is a UPS and M.2 NVMe SSD HAT for Raspberry Pi 5 designed to offer fast storage and protect the system against data loss during power
1 week ago 0 0 0 0
Preview
Sentinel Core - A Raspberry Pi CM5 mini-ITX carrier board with a PCIe x16 slot (Crowdfunding) - CNX Software Sanctuary Systems' Sentinel Core is a Raspberry Pi CM5 mini-ITX carrier board with a PCIe x16 slot to easily connect a graphics card and accelerate 3D
1 week ago 0 0 0 0
Preview
Nuvoton NuMicro M3331 Cortex-M33 MCU features built-in ARGB LED controller, optional USB 2.0 OTG interface - CNX Software Nuvoton's new NuMicro M3331 is a series of 32-bit Arm Cortex-M33 MCUs clocked at 180 MHz that integrate an ARGB LED controller, a DSP instruction set, a
1 week ago 0 0 0 0
Preview
Mekotronics R57-5S - Rockchip RK3576 mini PC and digital player integrates inclined 5-inch touchscreen display - CNX Software Mekotronics is known for its unusual Rockchip devices, and the R57-5S is a Rockchip RK3576 mini PC for kiosks and digital signage applications with a
1 week ago 0 0 0 0
Preview
Entry-level Intel Core 3 304 Wildcat Lake processor details and benchmarks surface - CNX Software Intel discreetly introduced the Wildcat Lake Core Series 3 CPUs at CES 2026 with some high-level specifications, but no part numbers or exact CPU, GPU,
1 week ago 0 0 0 0
Advertisement
Preview
Digi IX25 - A rugged 5G RedCap/eMBB industrial cellular router - CNX Software Digi International Digi IX25 is a rugged, industrial 5G cellular router designed for critical and enterprise applications. Built around a 1.2 GHz
1 week ago 0 0 0 0
Preview
Raspberry Pi 4 3GB launched for $83.75, further price increases announced across the board for 4GB+ RAM hardware - CNX Software This may sound like an April Fool's joke, but the Raspberry Pi 4 with 3GB RAM is real and now offered for $83.75. Raspberry Pi also announced another
1 week ago 1 2 1 0
Preview
Telink TL3228 - Low-power, low-latency dual-core RISC-V wireless MCU supports Bluetooth 6.0, 802.15.4, and 2.4 GHz proprietary - CNX Software Telink has launched the TL322x wireless MCU family, starting with the TL3228, featuring a 192 MHz dual-core RISC-V MCU, and supporting Bluetooth 6.0,
1 week ago 0 0 0 0
Preview
Toradex OSM and Lino SoMs - 30×30mm NXP i.MX 93/i.MX 91 modules with solder-down or B2B connector designs - CNX Software Toradex has launched two new ultra-compact (30x30mm) System-on-Module (SoM) families: OSM and Lino, powered by NXP i.MX 91 or i.MX 93 Arm Cortex-A55 SoC
1 week ago 0 0 0 0
Preview
Rockchip RK3506J-based Forlinx FCU1501 fanless industrial IoT gateway offers dual Ethernet, plenty of I/Os and serial interfaces - CNX Software Forlinx Technology has recently introduced the FCU1501, a rugged, fanless industrial embedded computer and IoT gateway built around the Rockchip RK3506J
1 week ago 0 0 0 0