Squad~

Skorcian Ascendant test print~

We cycled back to just a normal setup for the frame. I'll save the ideas from the other setups for later probably~

I'm...not sure. The Myriacor exists, and that's all balljoints so *technically* it would be a possible digital kitbash xD

(Regular legs for reference)

Started with regular legs but it felt more goofy then I wanted so I popped it onto a quad platform to test if I like the vibe~

At this rate, it's probably going to be the largest departure from the base frame. The Arkhos had some pieces that would tie them together, but it's still a lot xD

Squad so far:

Aracort ascendant test print~

Better then them just telling you to kick rocks I guess xD

It came out at the same time the Corydora StrikeTeam set did, along with the dogfish~

And through the power of kitbashing, it gives you one of the cooler ways to set up a broadside analogue:

After going through and doing all the purchase transfers for the FishMech filesets, this is my least sold set:

It's ok MonkeyFish. I think you're cool.

My stuff kinda just winds up on pinterest:

I don't do any editing or the like, just renders pulled from fusion and it still thinks those are AI.

One of the folks in my discord immediately described it as gamer posture and I can't argue that x'D

Makin the Skorcian Ascendant just, a scrungly guy.
I've personally wanted to do something like this since I modeled those segment pieces x'D

It'll look way better posed around that column I promise~ the base pose is kinda rough imho.

Once you get into 6+ limbs, trying to coordinate them all is a pain x'D
But I do really like 'em~
Aracort Ascendant (probably)

Test of the Nulsidhe Ascendant~

Puttering around with a spooder~ (Ascendant Halo missing in this render)

Probably less a wercor ascendant, and more just, a newer wercor kit. It's kinda aesthetically old, and the vibes have changed a bit since then, but I have no idea when that actually get done xD

Nahhh Fiber finally came through my little loop~

But this is a wired connection to my work tower~ Wifi is about 1/3rd of that.

@warframe.com continues to ever be a source of inspiration for me~ x'D

I really am partial to how the Solis came out though~

Goshhh these were from so long ago x'D

@karondkar.bsky.social on my discord got one of the Solis ascendant's done up and I had to cross post it here~

(Insta's got a bit more stuff on it same name as the bsky's new~)

It's all magnets all the way down~

This took forever to render on the laptop. My desktop spoils me so xD
Nulsidhe Ascendant~

I've seen a few folks have a hard time with it, I know it likes to be printed at relatively warm temps, and I spent a couple days calibrating to my usual Amerilabs test, but I haven't had anything on it dust from friction contact.
Shame, it worked a treat for me :c

Resione M58 was what I used for my Woundwort. It's a little expensive, but is one of the best mechanical resins I've found. I don't do a lot of posing, but the joints are still good~

But you're right in that regular resins just aren't for this.

Got the test print of the Ascendant Osteos~

Nah, they can be posed, but still need to be glued unfortunately

Thank you~ I think they're a good lil' sampling 😌