My first @PrintedSolid #Jessie print ever. I can see why people love this stuff. Great print of this @cinderwing3D #BabyRoseDragon on the @BambulabGlobal #X1Carbon with zero calibration. I even swapped nozzles just before this. Loaded filament, sliced, bed level, print. Perfect.
Whoops, forgot to post when I started my next #3DPrint on @MakerDeck: @cinderwing3D #BabyRoseDragon, #BabyCoralReefDragon and #BabyCrystalDragon in @Proto_pasta #NebulaSilverSilk … only an hour and a half left to go now 😹 https://www.twitch.tv/makerdeck
This is, by far, the best @MatterHackers #MHQuantum @cinderwing3 #BabyRoseDragon I have ever printed. I had a lot of trouble with it on the Ender, but @BambulabGlobal #X1Carbon printed this flawlessly at 70% in about 3 hours. Too bad camera feed dropped me from @MakerDeck
Now streaming on @MakerDeck - @cinderwing3 #BabyRoseDragon in @MatterHackers #MHQuantum in pink/yellow on the @BambulabGlobal #BambuX1Carbon https://www.twitch.tv/makerdeck
I continued my quest for good print settings by repeating using @PrusaSIicer instead of @Ultimaker #Cura - 1st attempt wasn’t pretty, but with some advice from @cinderwing3 discord, I got GREAT results. Have a #BabyRoseDragon going now in @MatterHackers #MHQuantum yellow/blue.
Number 5 in a series of 7 by request, #BabyRoseDragon #3DPrint by @cinderwing3 in @Proto_pasta #FlecknFireRedGlitter ❤️❤️❤️
Would have streamed on @MakerDeck but the studio was full this morning 😂
Ned to work on my settings a bit, she’s a bit rough. But still adorable #BabyRoseDragon by @cinderwing3 printed in @MatterHackers #MHQuantum in pink/yellow
