Two mechs of different sizes, both with cylinder-shaped bodies, walk past a small factory.

The smaller one, shown from the opposite side. It has two emblems on the hull: - number 123, white on red - and some small rodent with long tail, black on white The cylinder itself is painted in a very messy camouflage, pale blue, dirty yellow, dull orange and a bit of grey.

View from the back. A door on its side, with stepladder below, can be seen.

A second, smaller cylinder walker.

Aside from the gun, fully scratchbuilt.

#miniaturepainting

A top-down view of a diorama board - symmetrical arrangement. Central block of two levels with staircases, connected by bridges with the two triangular sections in the opposite corners. The ground level is partially snowed and flooded.

I had this 6mm Necropolis board, and the horrible water effects (why even use them??? Gloss varnish does the job!) turned into gross white thing.
I touched it up and masked it with snow (and gloss varnish).

It is up for sale.

#necropolis28

A mech, wide cylinder on spindly legs, is aiming with a very normal German submachine gun - next to a ruined 20th century house. The house, two stories and a roof, only comes to its hip. The mech is khaki, and most of the cylinder is covered in vertical stripes of zimmerit.

View from the left. It has a larger flat shield on this shoulder, with two square emblems - number 122, white on red; and a cangaroo, red on white.

View from the back. It carries several barrels, pale blue with a white middle. There's a door with a stepladder to the side. Beneath its feet, is a ruined staircase.

View from the right. The spindly legs and arms are in full view.

Really wanted to make a mech in other genres/periods.

#miniaturepainting

A group of tiny Ancient Greek houses with white walls and red roofs. There is a bronze statue of a Hoplite next to one.

View from another angle.

Another angle yet, showing little fences between the houses.

Photo with a giant mech for comparison.

Something that remained unfinished for years.
Lasercut houses from Iliada Game Studio.

#miniaturepainting #tabletopterrain

A pale wreckage of a mech, with a pilot in bright orange clothes standing next to it.

View from the other side.

The same wreck, with a little black mech standing next to it. The mech consists of backward legs, clunky body, and a large cannon attached to its side.

View from the back.

Some more of this.
A wreck with a pilot, and another tiny mech with scratchbuilt legs.

#miniaturepainting

A group of three mechs of very different sizes, all black, all with chicken legs.

The smallest, shown separately from behind. It consists of a large rocket system on spindly legs, with a cockpit in front and a red barrel in the back. There is a step ladder on one thigh.

Another tiny mech - this time, on scratchbuilt legs.

#miniaturepainting

A concrete wall, grey and made of vertical sections, with open gate, in which a black short walker stands.

View from the other side. The wall sections have a peaceful mural on them. The walker is labeled "POLICE".

Another wall section, and the gate.
And, a smaller walker for context.

#miniaturepainting #tabletopterrain

A floating mech, light blue. It has a helicopter-shaped body, with legs below and both arms and wings attached at the shoulder. It is standing on its toes, holds a thin red spear, and has a nose art of gaming dice on the nose.

View from the back. Wings in full view.

Photo with another mech, white and orange. They are roughly the same height, with helicopter mech being slightly larger.

And another mech.
This time, using Battletech body and Gundam wings, with legs constructed out of Gundam parts and plastic rods.

#miniaturepainting.

A black mech with a glowing red sword. It has reverse knees, no head, and two cannons embedded into its shoulders. It has tiny glowing bits all around. There is a concrete wall behind it, and a base with super-tiny figures wearing black.

View from the back. In the other hand, it holds an appropriately-sized rifle.

This one is intended to represent the people behind this wall.

Simple kitbash, using a 3d printed Battletech figure and resin cast Infinity arms.
Tiny people next to it, are way more converted (I sculpted capes on two of them).

#miniaturepainting #flamesoforion

A pale blue mech with enormous side shields on its shins. Its body is a mess of complicated equipment, its left arm is yellow and ends in a circular saw.

View from the right. This side shield has a pinup of a woman in bright red bodysuit riding a bomb. She has black hair, and her face is eclipsed by a glowing star. She has a halo around her head.

View from the back, showing the complicated legs.

I got a few more Battletech prints, and here comes the first proper Battletech/Gundam kitbash.
The legs use Strike Gundam skeleton with sculpting, plastic rods and HG gunpla parts.
The pinup is painted over a decal.

#miniatures #battletech #gunpla

A composition of scenery pieces - complicated concrete buildings behind a wall. The wall consists of vertical concrete panels, with a red horizontal stripe at the top. There is a concrete bunker protruding from the wall.

Close-up of said bunker. There is a satellite dish on top, an an imperial eagle on one of the wall panels. Each panel has a wider bottom.

View of the other side of the wall. Each panel has an optimistic landscape painted on, with blue skies, mountains and green trees. There is a ruined building behind the wall, and a streak of rusty-orange moss between two panels.

Photo of the wall (outer side) with an orange mech for scale.

More 6mm terrain.
Dystopian city walls, this time.
The wall is roughly 18m tall (6cm in this scale). It is barely tall enough to hide Gundam battles on the outside.

#miniaturepainting #tabletopterrain

Three sections of broken rocky hills in a desert, with a mech for scale.

Close-up of one terrain piece - broken bridge with two cars, one below and one teetering on the edge. Both have rusty overgrowth near them.

View from above, the bridge remains and the road leading to it - still with its original yellow markings.

More tiny terrain.




#tabletopterrain

Two orange mechs, heavy bodies with small arms in front holding a gun. There is a base of tiny infantry figures next to them. The mechs are about 15m tall.

View from the left. The right mech rests its left foot on a massive broken head of a statue. It has a decal of playing cards, and "SALLY" written next to it.

View from the back. Both have a number written on the right side. There is a teal cable going to the arm from the back.

And now, to my very first Battletech models.
These are 3d-printed (not by me) and converted.

#miniaturepainting

A giant robot, painted white red and blue with yellow accents, is perched crouching on some rusted machinery.

View from the left. Its body is an exposed spine, with blue armour plates in the front. The head, resembling an animal skull, has a glowing red eye.

View from the back. A bit blurry.

A size comparison photo with imperial grunt mech Doru. Ancyor is almost as tall, despite its crouching pose.

The messy pinnacle of this project: Heroic Robot Ancyor from @kallidorarho.bsky.social WARHOUND.
It ended up being -very- different from what I initially thought to make, but it is here and it is done.

#miniaturepainting #gunpla

A small model of a residential building vaguely inspired by Japanese architecture. It has brick walls on the first floor, and balcony windows for the rest, separated by tall concrete columns. The roof comes in two separate halves, slanted to each side, on different levels. There are some advertisement banners on top.

A side view of a flat wall, with a large mural of a heroic factory worker.

View of the other side of the building. A yellow gas pipe goes around it above the first floor, and there are various vending machines or ATMs next to it, as well as graffiti. It's really small - the whole 4-5 story building is about 5cm tall.

View of the other flat wall, with more yellow pipes.

A scratchbuilt building in 6mm scale, from back in 2022.
#miniatures #tabletopterrain #6mmscale #inq6

Some 6mm-scale tanks painted way back in 2020-2021 - sculpted by @tim-popelier.com , who apparently has an account here.
#6mmscale #inq6 #grimdark #miniatures