Using a 1/16” diameter ball nose end mill to run the finishing pass on this Millennium Falcon tray. I generated the tool paths in Vectric CNC software. The Redline spindle was running at 200 ipm. I will cut the tray loose and do a sanding.

#vectric #onefinitycnc #redlinecnc #CNC #catchall

Time to cut off the back piece from the 3D carve on the Onefinity CNC using the Harvey C14 bandsaw. The file was created in Vectric CNC software after scanning the original bear using the Einstar Vega 3D scanner.

#einstar3d #harveywoodworking #vectric #onefinitycnc #CNC

Check out how great this copy of my grandfather's bear carving turned out on the Onefinity CNC with the new Redline controller and spindle.

Used Vectric CNC software to create tool paths for the 1/4" roughing bit and the 1/16-inch ball nose end mill.

#vectric #onefinitycnc #redlinecnc #CNC #bits

Now it’s time to use the 1/16-inch diameter, bullnose and mill for the finishing pass on this bar carving. There isn’t much material to take off in the finishing pass since the roughing pass takes most of it off.

#vectric #onefinitycnc #redlinecnc #CNC #bits #rcarving

This was scanned with the Einstar Vega scanner and then brought into Vectric CNC software for the carve. I really like the visualization of carving in the software as it will show the roughing and detail pass.

#vectric #onefinitycnc #redlinecnc #highcountrytools #CNC