Photo of an Elegoo Neptune 4 Max 3D printer mid-printing.
Photo of an Elegoo Neptune 4 Max 3D printer with a finished soap holder on the table. The soap holder is lying on its side, as this orientation made printing without support beams possible.
The soap holder in action, holding a piece of soap. The design was not for beauty, but for usability. The body is wedge-shaped, with a jagged profile both on top and below to allow water to pass through. There are triangular posts holding the soap in place.
First successful #3DPrinting project.
This is the soap holder I drew in #FreeCAD yesterday.
It isn't perfect, as I still need to play a bit with temperatures and extrusion speed, but it's decent enough to keep.
#SuperSlicer is pretty impressive too […]
[Original post on mastodon.gamedev.place]