Out now: the #E1702Sdock ist the easy way to connect the #E1702S #scannercard with #scanhead and #laser: just 1:1 #flatbelt connections between card and #dock, laser and scanhead plugged to the #DSUB25 connectors and power applied to the screw terminal - that's it!

#HALaserSystems

Closing the last remaining, technological gap: the #SDP extension board for the #E1803D #scannercard now allows it to control #scanheads that make use of the serial data protocol (typically used in NewsonNV scanheads).

For further information visit our webpage or contact us 📨

We're celebrating our #10thAnniversary !
In #November #2014 #HALaserSystems started with the #E1701D #XY2-100 #scannercard and with the first version of the #BeamConstruct #LaserMarkingSoftware .
Ten years later, we're the technology leader in laser marking business...

Out now: #NX02 is a new #scannercard #interface which is more simple to use and to connect than everything else out there: up to three axes can be transferred using two simple wires - and even the polarity of these #wires does not matter.

#HALaserSystems

Our #scannercard s are already known for an extremely low #powerconsumption - with hardware revision 1.8 this could be reduced even more for #E1803D #controller. During operation, it consumes about 25% less compared to previous versions - and resulting from that it produces less heat.#HALaserSystems

Meaning of the user-LEDs at the #E1803D #scannercard:

AE: "Alive/Error" #firmware/controller state

MA: "marking active", marking operation in progress

LG: "laser gate", LaserGate output state

MO: "main oscillator", shows the state of the MO-output (#MOPA-lasers only)

#HALaserSystems