Advertisement · 728 × 90
#
Hashtag
#quenching
Advertisement · 728 × 90
Abstract:  Understanding the abundance of atomic oxygen in the vicinity of carbon surfaces exposed to high-enthalpy flows is critical to accurate predictions of the gas–surface interaction. A novel approach for obtaining absolute number density measurements of atomic oxygen in high-enthalpy facilities with nanosecond laser pulses is described and demonstrated using photoionization-dominated, two-photon laser-induced fluorescence. In two-photon laser-induced fluorescence measurements, the depopulation of the excited state is typically dominated by electronic quenching, which depends on the temperature, pressure, and gas composition. To account for the electronic quenching rate, the fluorescence lifetime can be measured by temporally resolving the fluorescence. This can prove challenging in high-temperature and/or high-pressure environments where the fluorescence lifetime can be less than a nanosecond. Instead, by increasing the laser intensity until photoionization dominates the depopulation of the excited state, we create a quenching-independent measurement that is proportional to absolute number density. This technique is demonstrated here in the reacting boundary layer of a graphite sample ablating in the 6000 K plume of an inductively coupled plasma torch. The boundary layer possesses a large temperature gradient that varies from about 2000 K near the sample surface to the plume temperature of 6000 K in a span of approximately 2 mm. The photoionization-dominated technique is calibrated by using the freestream oxygen concentration, assuming the torch plume is in local thermodynamic equilibrium. The spatial resolution of the measurements is 50 µm and we are able to measure the number density of atomic oxygen to within about 60 µm of the graphite sample.

Abstract: Understanding the abundance of atomic oxygen in the vicinity of carbon surfaces exposed to high-enthalpy flows is critical to accurate predictions of the gas–surface interaction. A novel approach for obtaining absolute number density measurements of atomic oxygen in high-enthalpy facilities with nanosecond laser pulses is described and demonstrated using photoionization-dominated, two-photon laser-induced fluorescence. In two-photon laser-induced fluorescence measurements, the depopulation of the excited state is typically dominated by electronic quenching, which depends on the temperature, pressure, and gas composition. To account for the electronic quenching rate, the fluorescence lifetime can be measured by temporally resolving the fluorescence. This can prove challenging in high-temperature and/or high-pressure environments where the fluorescence lifetime can be less than a nanosecond. Instead, by increasing the laser intensity until photoionization dominates the depopulation of the excited state, we create a quenching-independent measurement that is proportional to absolute number density. This technique is demonstrated here in the reacting boundary layer of a graphite sample ablating in the 6000 K plume of an inductively coupled plasma torch. The boundary layer possesses a large temperature gradient that varies from about 2000 K near the sample surface to the plume temperature of 6000 K in a span of approximately 2 mm. The photoionization-dominated technique is calibrated by using the freestream oxygen concentration, assuming the torch plume is in local thermodynamic equilibrium. The spatial resolution of the measurements is 50 µm and we are able to measure the number density of atomic oxygen to within about 60 µm of the graphite sample.

New from Applied Spectroscopy!
Quenching-Independent Two-Photon Absorption Laser-Induced #Fluorescence Measurements of Atomic Oxygen in High-Enthalpy Air/Carbon Gas–Surface Interaction
Read more: https://doi.org/10.1177/00037028251388670
#SAS #Spectroscopy #TwoPhoton #quenching #AtomicOxygen

2 0 1 0
Post image

Zhaonan Jin et al in ACS Applied Materials & Interfaces (@ACS_AMI): #Gas #quenching under ambient conditions for #efficient and #stable #wide-bandgap #perovskite #solar cells with #surface #passivation

ACS Appl. Mater. Interf. 18, 1702-1713 (2026)

doi.org/10.1021/acsa...

1 1 0 0
Original post on astrobites.org

Observing the End of Star Formation in Galaxies These galaxies are on the brink of entering their “quiet” phase. Title: Searching Within Galaxies for the Earliest Signs of Quenching With Spatia...

#Daily #Paper #Summaries #galaxy #evolution #quenching […]

[Original post on astrobites.org]

0 0 0 0
Original post on astrobites.org

A Tale of Two Quenching Pathways Do galaxies shut off star formation from the inside-out or the outside-in? And what does that tell us about their history? Title: Building up JWST-SUSPENSE: inside-...

#Daily #Paper #Summaries #cosmic #noon #galaxies […]

[Original post on astrobites.org]

0 0 0 0
Post image Post image

Our team next posters at #SolTech #Conference in #Bayreuth: Xiaojing presenting Reorientation-Driven #Degradation in Oriented #Perovskites: Shifting
Facet #Engineering and Zhaonan presenting #Gas #quenching under ambient conditions for #efficient and stable wide #bandgap perovskite #solar cells

1 0 0 0
Post image

[Open Access]
Controlling fluorescence quenching efficiency by graphene oxide in supported lipid bilayers using SiO2 layer fabricated by atomic layer deposition
2023 62 SC1041

iopscience.iop.org/article/10.3...

#JJAP
#physics
#Openaccess
#lipid
#bilayer
#graphene
#oxide
#fluorescence
#quenching

0 0 0 0
The quarry was created by the open-pit mining of bedrock limestone. Mining stopped in 1932 and nature has taken over. The 90° angles have been softened by vegetation and the occasional slump that causes chunks to break away. Limestone is particularly prone to breaking up during the freeze thaw cycle because the stone is semi permeable The turquoise colour of the water is caused by the Dolomites and limestone that surround it. 
The photograph shows the edges of the former quarry, including a 90° corner. You can also see the sharply angled breakage in the limestone, with a large boulder, the size of a human being inside the crack. You can also see vines, young bushes and saplings taking root in the cracks of the limestone. Over a very long period of time (greater than human scale), the vertical lines of the quarry will disappear and become a sharp slope. In the water below, there is one person (apparently male) swimming in the cool water.

The quarry was created by the open-pit mining of bedrock limestone. Mining stopped in 1932 and nature has taken over. The 90° angles have been softened by vegetation and the occasional slump that causes chunks to break away. Limestone is particularly prone to breaking up during the freeze thaw cycle because the stone is semi permeable The turquoise colour of the water is caused by the Dolomites and limestone that surround it. The photograph shows the edges of the former quarry, including a 90° corner. You can also see the sharply angled breakage in the limestone, with a large boulder, the size of a human being inside the crack. You can also see vines, young bushes and saplings taking root in the cracks of the limestone. Over a very long period of time (greater than human scale), the vertical lines of the quarry will disappear and become a sharp slope. In the water below, there is one person (apparently male) swimming in the cool water.

#Quenching the Heat at the Elora #Quarry
The quarry was created by the open-pit mining of bedrock dolomite (on the left) and limestone.
#AlphabetChallenge #EastCoastKin #WeekQforQ #WeekQforQs #BedrockOfBlueSky 😉
#PhotographersOfBlueSky

37 2 2 0
Post image

#Quinine in my thirst #quenching Gin & Tonic
#AlphabetChallenge #WeekQforQ
#EastCoastKin

27 1 1 0
Post image

A lovely thirst #quenching pint of TT

#AlphabetChallenge #WeekQforQ
#EastCoastKin

10 0 0 0
Post image

#hellokity #quenching
strecthyourdollars.com/hello-kity-c...

0 1 0 0
Post image Post image

This glorious cup of coffee☕️ #Quenching me...I can #Taste the #Music 🎵 #TheMusicOfCoffee 😁🎷

2 0 0 0
Post image

Homochiral BINOL-Based Metal–Organic Frameworks for Luminescence Sensing of Hydrobenzoin Enantiomers | Inorganic Chemistry pubs.acs.org/doi/10.1021/... @wenbinlin_uc and co-workers @InorgChem #zinc #cadmium #CMOFs #BINOL #hydrobenzoin #enantiomers #luminescence #quenching

2 0 0 0
Post image

Investigation of the Effect of Sb3+ Ion on the Spectroscopic Properties of Eu3+-Doped YVO4 Nanosized Materials | Inorganic Chemistry pubs.acs.org/doi/10.1021/... Bartkowiak, Wiglusz, and co-workers @InorgChem #antimony #europium #YVO4 #nanomaterials #bismuth #quenching

1 0 0 0